Storage Instructions

It is advisable to store Alupanel in a clean dry area with a minimum temperature of 15°C for a duration of 24 hours before use. After 24 hours of storage you will be able to start the processing requirements for each panel. It is important that when the sheets are not in use that they are properly taken care of. This means introducing a polystyrene layer or similar between sheets to stop any damaged occurring. After Alupanel has been removed from the stack it must be protected from the penetrating moisture. Always stack the product on a level surface horizontally and never vertically.

Protective Equipment

In all cases you should follow the safety practices of your work place. However we advise you handle any sheet with gloves and where appropriate use goggles, face mask and ear plugs, when processing.

Protective Films

The film that is on both sides of the panel is a protective measure whilst the panel is being processed, installed and also in transit. This film should remain on the panel for the duration of the installation only. You must remove this film once the panel has been fixed and set in place.

Due to the nature of the finishing process the paint has a directional quality. Care must be taken when using multiple sheets to ensure the panel is installed in the same direction.

Handling Alupanel Sheets

You should handle Alupanel with a degree of care and where there are long lengths
involved it is advisable that a team of you carry out the handling. When removing panels fro a pallet/stack never drag the panel, always lift clear above the remaining panels on the stack. This will require two or more operatives.

Cleaning

Regular cleaning may be required depending on where the panel has been used.
• A moderate amount of pressure is all that’s needed in order to clean the surface.
• It is important that you avoid any alkaline, acidic and abrasive cleaning products  
   as this can have an adverse effect on the panel’s polyester coating.
• When the panel has been cleaned you should rinse off with clean water and rub 
   down with an absorbent cloth/leather to remove any residue left behind.