This Formply is used in the construction industry to set concrete in position.  It is extremely strong, stiff and durable, far out performing other formplys in every aspect.  With proper on-site care 23-30 re-uses are assured.  It is ideally suited for fixed formwork application i.e. tableform, jumpform, etc.  it will not delaminate.

The immense strength and stiffness of our formply allows for very significant savings in support structures and labour, and when coupled with its durability and high re-use qualities will drastically reduce formwork costs on construction sites.

SPECIFICATIONS:

Sheet Size:	2400mm x 1200mm and 1800m x 1200mm
Thickness:	Nominal 17mm – 7 Ply
Adhesive:	“B” Bond (Exterior) Resin Australian Standard – 2271
Quality Control:	Our plywood is produced in accordance with the strict quality control programme of the Plywood Association of Australia who provide an independent third party audit
F Rating:	Our F17 formply is stress graded in accordance with Australian Standard – 2269 Structural Plywood.  It is suitable for class 2 finish
Colour:	Green Yellowstripe
Edge Sealing:	Water resistant edge sealing paint
Overlay film:	60 gsm (grams per square meter) high density phenolic resin impregnated paper on both sides
Construction:	HWD Face Pinecore

Stress Grade	Bending Fb	Tension Ft	Shear Fs	Compression FC	Modulus of Elasticity E	Modulus of Rigidity G
F17	17.0	10.2	2.3	12.8	14000	700
F11	11.0	6.6	1.8	8.3	10500	525

These properties ensure maximum savings in plywood requirements, support systems and labour.